Flat Rate Roofing

Florida Certified Roofing Contractor CCC 1334537

Shingle Roofing in Sunrise, FL

Shingle Roofing for homes in Sunrise and the surrounding area — from our Sunrise headquarters. Free quote.

Sunrise is a city of roughly 96,800 people in a humid subtropical zone, with a wet season of near-daily thunderstorms, heat indexes above 100°F and a hurricane season that runs June 1 through November 30. Broward County is one of the two counties designated as the High-Velocity Hurricane Zone under the Florida Building Code, so asphalt shingle roofs here are working against constant UV, wind-driven rain and wind uplift at the same time. Most of the city was built out between the late 1960s and the 1990s in concrete block and stucco, with gable and low-slope roofs in asphalt shingle, concrete or barrel tile.

Flat Rate Roofing Inc works on shingle roofs across Sunrise from our office at 9610 NW 24th St. A shingle project here normally means a full tear-off to the deck, an inspection of the sheathing, plywood and fascia replacement where we find rot, a secondary water barrier where it is required, and architectural shingles rated for Florida wind zones with starter strip, ridge cap, drip edge and valley detailing. We pull permits under our own license, schedule the inspections, and close the permit out. The company is insured, and every job starts with a free estimate and a written flat rate quote that says what is included.

According to U.S. Census Bureau ACS 5-year (2022) data, the median Sunrise home was built around 1982 and most homes are owner-occupied — meaning much of the housing stock is now 30 to 55 years old and many roofs have already been through at least one covering. The city's western edge backs up to the Everglades water conservation areas, so homes deal with a high water table, heavy summer rainfall and intense sun that beats hardest on west- and south-facing slopes. Sunrise sits about 10 miles inland from the Atlantic, so direct salt spray is limited, but humid onshore air still drives corrosion on fasteners and flashings. A large share of the city is governed by mandatory HOAs or condo associations, including age-restricted and gated communities, and those associations often control or must approve roof work.

Problems to watch for in Sunrise

UV and heat aging the asphalt

Constant sun and heat indexes above 100°F age asphalt faster here than in northern climates. Granule loss and brittle, curling shingles usually show first on west- and south-facing slopes.

Wind uplift and blow-off

Broward sits in the High-Velocity Hurricane Zone, and shingles and underlayment used here must be HVHZ-approved with a Miami-Dade NOA. After a storm, lifted tabs or a missing course can let wind-driven rain under the covering.

Poor attic ventilation

Inadequate attic ventilation shortens shingle life by cooking the underside of the deck in Sunrise's heat. Ridge and off-ridge vents are part of how we detail a replacement roof.

Algae, mold and mildew

High year-round humidity encourages algae, mold and mildew on roofs and in attics across South Florida. Dark streaking on a shingle roof is a sign to have the surface and the attic looked at together.

Rotten plywood and fascia

On homes dating from the 1970s and 1980s, a tear-off often exposes soft sheathing or fascia that has taken years of wind-driven rain. Replacement of rotten plywood and fascia is included in our scope.

Corroded fasteners and flashings

Humid onshore air accelerates corrosion of fasteners and flashings even 10 miles inland. Valleys, roof-to-wall transitions and penetrations are the places that usually give out first.

Missing wind mitigation documentation

Re-roofs commonly trigger deck re-nailing, secondary water barrier and roof-to-wall attachment requirements, and those items also affect wind mitigation insurance credits. Confirm current requirements with your local building department.

What we do

  • Full tear-off and deck inspectionWe strip the roof to the deck so the sheathing can actually be seen, not guessed at. Anything soft or delaminated gets addressed before the new system goes on.
  • Plywood and fascia replacementRotten plywood and fascia replacement is included in the scope of our flat rate quote. On homes built in the 1970s and 1980s this is a normal part of re-roofing.
  • Secondary water barrier and underlaymentWe install a secondary water barrier where it is required, using underlayment approved for use in the Miami-Dade/Broward HVHZ. This is the layer that matters most during wind-driven rain.
  • Architectural shingles and edge detailingWe install architectural shingles rated for Florida wind zones, along with starter strip, ridge cap, drip edge and valley detailing. The edges and valleys are where uplift starts, so they get detailed deliberately.
  • Ridge and off-ridge ventilationVentilation is set up so the attic can breathe through Sunrise's long hot season. Better airflow protects the deck and the shingles above it.
  • Permits, inspections and cleanupWe pull the permit under our own license, schedule the in-progress and final inspections, and close the permit out. Cleanup includes a magnet sweep of the grounds.

Licenses, permits and codes in Sunrise

Asphalt shingle roofing requires a licensed contractor in Florida — normally a state-certified or state-registered roofing contractor through the Florida Department of Business and Professional Regulation (DBPR) and its Construction Industry Licensing Board (CILB), or a general/building contractor working within scope. Local county and municipal building departments and contractor licensing boards also play a role in South Florida. Flat Rate Roofing Inc holds Florida Certified Roofing Contractor license CCC1334537, a state certification valid in every Florida county, and you can verify it on DBPR's license lookup. A permit is required for re-roofing and for most shingle repairs beyond small maintenance; in Sunrise it is issued by the city building department, with required in-progress (sheathing/nailing and underlayment) and final inspections. Because Broward is in the High-Velocity Hurricane Zone, shingles and underlayment must be HVHZ-approved with a Miami-Dade NOA, and re-roofs commonly trigger deck re-nailing, secondary water barrier and roof-to-wall attachment requirements — confirm the current requirements with the Sunrise building department, and check with your HOA or condo association before scheduling.

Verify our licenses at Florida DBPR.

When to call

Demand in Sunrise spikes ahead of and during hurricane season, June through November and peaking August through October, with a second bump in the dry winter months when seasonal residents return and deferred repairs get scheduled. The dry winter window is generally the better time for a planned shingle replacement, since near-daily thunderstorms in the May-through-October rainy season complicate any open tear-off. To get started, call (954) 775-8990 or request an estimate with the form on this page. The phone is answered around the clock, and the office keeps weekday hours, Monday to Friday, 8am to 6pm.

We serve shingle roofing throughout Sunrise, including Sunrise Golf Village, Welleby, Springtree, Sunrise Lakes, New River Estates, the Sawgrass Mills area, the Civic Center / City Hall area, and the Flamingo Road, Nob Hill Road and Sunset Strip corridors.

Shingles in Sunrise: questions we hear

Do I need a permit to replace a shingle roof in Sunrise?
Yes. A permit is required for re-roofing and for most shingle repairs beyond small maintenance, and it is issued by the city building department. There are required in-progress inspections for sheathing/nailing and underlayment, plus a final inspection — we pull the permit under our own license and see it through to close-out.
My community has an HOA. Does that change anything?
Mandatory HOAs and condo associations govern a large share of Sunrise, including age-restricted and gated communities, and in many of them the association controls or must approve roof work. Check your association's approval process and any color or product restrictions before work is scheduled. We can supply the product information you need for a submittal.
Why do shingle roofs wear out faster here?
UV and heat age asphalt faster in South Florida than in northern climates, and inadequate attic ventilation shortens shingle life further by trapping heat under the deck. Humid air also corrodes fasteners and flashings, and wind uplift during hurricane season stresses edges and valleys. Ventilation and proper edge detailing are a real part of how long a new roof lasts.
Are you licensed and insured?
Flat Rate Roofing Inc holds Florida Certified Roofing Contractor license CCC1334537, a state certification valid in every Florida county and verifiable on the Florida DBPR website. The company is insured. Roofing legally requires a licensed contractor in Florida, so always confirm a license number before signing anything.
What does a quote include?
We provide a free estimate and a written flat rate quote that states what is included, with rotten plywood and fascia replacement in the scope. Permits are pulled under our own license, inspections are scheduled and passed, the permit is closed out, and cleanup is part of the job.

Get a free shingles quote in Sunrise

Tell us what's going on. A state-certified contractor will get back to you.

Prefer to talk?

(954) 775-8990

One number for Broward, Miami-Dade, and Palm Beach.

We only use your details to respond to your request. See our privacy policy.

(954) 775-8990Get a quote